I have taken the following at the camera module of raspberry pi
$ raspistill-o image.jpg
I think it's basic commands.
However, an image that is visible between the display for 5 seconds, an image actually shot are different.
For example, an object that is to be displayed in full screen during the 5 seconds, looking at the image that was actually shot, I feel the object is displayed in a small size in the image.
Should this happen? Failure?
I'm having problems when not know have been examined causes
# I think it also be due because you change the focal length
Is there a way to fix this? Or Is there such as a command to capture an image that is displayed for five seconds?
The preview code uses a video mode so that it can run at 30fps, when the capture is made, the mode used is a high resolution one, which uses a larger part of the sensor.
This is on my list of bugs to fix (ie new video mode that works at full frame)
Principal Software Engineer at Raspberry Pi (Trading) Ltd.
Contrary to popular belief, humorous signatures are allowed. Here's an example...
“I own the world’s worst thesaurus. Not only is it awful, it’s awful."