I just purchased a Raspberry Pi 3 Model B+ and a Raspberry Pi Camera Module V2 camera.
I am running NOOBS 3.0.1 and ran all the updates whe I first installed the software.
I ran the sudo apt-get update and sudo apt-get upgrade commands successfully.
I also ran the sudo raspi-config command and enabled the camera.
I rebooted my Raspberry Pi.
I ran the following in Python:
from picamera import PiCamera
from time import sleep
camera = PiCamera()
and get the below error
picamera.exc.PiCameraError: Camera is not enabled. Try running 'sudo raspi-config' and ensure that the camera has been enabled.
I triple checked that the ribbon cable is installed correctly.
When I run the vcgencmd get_camera command, I always get supported=1 detected=0.
I am very new to Raspberry Pi, so any help would be greatly appreciated.