Just another case design…
This case has been designed with the accurate mechanical data in mind and some tolerance has been added to compensate for uncertainties. The differences only add a millimetre or so to the size, as i had to compensate for the vaporised section of acrylic while it was being cut.
The design is to be cut from 3mm thick material (I recommend the material to be clear because it allows the lettering and logo to be visible through the case and not add a rough touch to the case) and assembled around the pi, then glued together with the pi inside. This means that the only way to remove the pi from the case it to break the bonds of the case apart however if good acrylic bonding agent is used this wont do any damage to the case and it can just be re-bonded afterwards.
Here are a few pictures of the finished product…
Any feedback is appreciated (although good feedback is best!). Thank you for looking.
I cant find the file I used on the pictures but I've uploaded the ones i do have. They're exactly the same dimensions and layout, just without the text and the name added ill upload the one used in the picture when I find it.
Downloads (without labels) V 0.7 :