Debiano wrote:Should be easy but i dont know how to place the chips on the boad.
You should put elements (and connect them together) on schematics. Your screenshot is showing a board editor.
Switching between board and schematics can be done by clicking on the 4th icon on the horizontal toolbar (just below top most menus). The icons in this toolbar are (from left to right): open, save, print, CAM processor and then this mentioned switching icon (you can switch back from schematics editor by clicking on this same icon).
The idea is to have for each design a schematics+board pairs. The application takes care about syncing them automatically. So, when you apply a change in one of them, it appears also in another immediately. For example, when you add a component in schematics editor, this component appears also on the board.
Keep in mind basic facts:
- schematics editor is the right place to perform the components and connection manipulation,
- board editor is the right place to move components on the board and route traces (according to existing un-routed connections synced from schematics).
Debiano wrote: I want to order on seedstudio and ive read i need to apply his rules.
An icon for loading/checking the board rules is placed on vertical toolbar located on the left side. This icon is last in right column, its tooltip text is DRC (Design Rules Check). Click on it, a new dialog opens where you can load rules, edit them and also perform the check.
(Icons are not the only way to get these functionalities... Currently, it's enough that you know at least one.
Best wishes, Ivan Zilic.