My thoughts on this after a whole lot of research:aeary wrote:Backstory, I am a computer/networking guy that is more than adept with a soldering iron but still fairly fuzzy on anything more complex than a basic circuit. I have seen suggestions of using an optical isolater (octocoupler) or a solid state relay to do what I am attempting to do...does anyone have any more specific information on setting this up in conjunction with the GPIO pins to simply complete circuits?
Hi Richard,Richard-TX wrote:Why don't you use solid state relays?
- 3-32 volt triggerable
- Opto isolated
- up to 40 amps@240 volt capable.
- Not expensive.
I use them for a variety of things; from controlling lamps, to controlling air compressor tank drains, to controlling two 1000 watt audio amplifiers.
Users browsing this forum: Yahoo [Bot] and 15 guests