jemartel wrote: ↑
Thu May 09, 2019 12:51 am
I just setup my crowdsupply stereopi. Using the included 8gb SD card and initially connected HDMI screen and keyboard, I booted my assembly without changing anything on the SD card "stereopi.conf". My assembly booted, I saw initial Linux text on screen and then nothing. But actually, I had an image coming from ONLY the right camera. I had wanted to setup configuration "assumed a desktop or raspi-config" but my keyboard and mouse were inop. I powered down and determined that the USB cable with plug mod needed to be installed to power the USB ports. I then again looked at the 8gb SD card and the "stereopi.conf" file, I changed to 3D mode, and added my wifi information. My WIFI and network use "10.0.0.xxx" settings, can I change the "192.168.1.10:3000" entry to "10.0.0.130:3000" and not muckup the streaming? Right now, all I see on the HDMI desktop is two strawberries, I also see same image of strawberries when I connect to the browser, I can access the admin panel via laptop browser and Android APP, but no video, only two strawberries. I have also tried the "SLP" image with same results no video from cameras.
I haven't tried default Raspbian Image yet, that is next test. I am assuming that the stereopi does not have a wifi module correct? and will require a USB stick module unless I leave network cable installed, but I still need to address network IP address that the SD card's appear hard coded to
Jemartel, looks like your camera cables inserted incorreclty (right like in this case
on our forum). If they are connected correctly, you should see 2 images on your HDMI monitor (quick equipment test
in our Wiki).
SLP image is not intended for keyboard and mouse. You may think of StereoPi with SLP as of a router. Usually you are not connecting keyboard, mouse and a monitor to your router, but use administration panel. For "desktop"-like experience you may use classic Raspbian (just add dt-blob.bin)
, or our Raspbian image with OpenCV.
StereoPi with WiFi dongle will get IP address from your router by DHCP. Address you see in stereopi.conf (that is 192.168.1.10:3000) is sitting in this row:
and means it is IP address for MPEG TS video stream, but not StereoPi IP address. You can see this address in Admin panel in your stream settings. So if you add WiFi dongle, StereoPi will have IP address according to your router settings (10.0.0.xxx).
Yes, StereoPi has no built-in WiFi, and you may use USB dongle you wish. Do not forget to set "wlan0" name in config file, as described here in our Wiki