Hey. So I have been trying to create a wifi access point by bridging eth0 and wlan0. I did a clean install, and when I connect ethernet, I can ssh into the pi. However, plugging in wifi adapter along with ethernet somehow kills the internet connection through ethernet, thus I cannot ssh into it. This was using the default /etc/network/interfaces. The only way I have been able to get it working is to modify the /etc/network/interfaces so that both eth0 and wlan0 are getting ip from dhcp. The problem is, I need to setup my network interface as shown in these tutorials:
http://blog.sip2serve.com/post/48420162 ... cess-point
http://www.daveconroy.com/turn-your-ras ... s-chipset/
Both tutorials give different methods of setting up the network interface, however neither of them work for me. After plugging in the wifi adapter and powering up, I get no internet whatsoever. Is there any reason why?
Wifi Adapter: Realtek Semiconductor Corp. rtl8188cus chipset