tmxk4197
Posts: 5
Joined: Fri May 10, 2019 1:39 am

How can I scan between LoRa using the LoRa (sx1278) module?

Sat May 18, 2019 2:39 pm

I am using two Dragino LoRa / GPS HATs to attach to the raspberry pie and try LoRa communication.

I also want to communicate LoRa over an IPv6 address.

To do so, I think we should have a physical connection between LoRa.

But I do not know how to do this and I do not know how to make a physical connection.

Does anyone know how to do this?

I would appreciate your reply.

Andyroo
Posts: 3306
Joined: Sat Jun 16, 2018 12:49 am
Location: Lincs U.K.

Re: How can I scan between LoRa using the LoRa (sx1278) module?

Sat May 18, 2019 3:29 pm

If you are talking about just using point to point communications and not the LoRaWAN system then this library may be of help https://github.com/YandievRuslan/sx1278 ... aspberryPi if you can code in C
Need Pi spray - these things are breeding in my house...

tmxk4197
Posts: 5
Joined: Fri May 10, 2019 1:39 am

Re: How can I scan between LoRa using the LoRa (sx1278) module?

Sat May 18, 2019 4:39 pm

Thank you for your reply !!

If so, can I use the above API to place the same scope link address between LoRa modules?

Andyroo
Posts: 3306
Joined: Sat Jun 16, 2018 12:49 am
Location: Lincs U.K.

Re: How can I scan between LoRa using the LoRa (sx1278) module?

Sat May 18, 2019 4:58 pm

I do not think that you have to issue any Pi addresses with point 2 point mode - it just broadcasts to anything in range.
Need Pi spray - these things are breeding in my house...

Return to “Networking and servers”