I purchased "Feetech FS90R 360° Continuous Rotation Micro Servo" and used if to make smart curtains. I used a very simple code (shown below).
I would like to make it slower but also keep a higher torque. Could you suggest me with some ideas on how to tackle this? Also, if you know how to make it quieter, that would be welcome as well.
Code: Select all
import time import pigpio pi = pigpio.pi() pi.set_mode(17, pigpio.OUTPUT) pi.set_servo_pulsewidth(17, 1400) try: time.sleep(40) finally: pi.set_servo_pulsewidth(17, 0)