Hard drive (IDE) interface & sketch
Does anyone know of an interface (shield) and control program (sketch) for either Arduino or Raspberry PI B+ that can transfer files from an old IDE hard drive to either SD card or USB flash drive?
-
DougieLawson
- Posts: 38883
- Joined: Sun Jun 16, 2013 11:19 pm
- Location: A small cave in deepest darkest Basingstoke, UK
- Contact: Website Twitter
Re: Hard drive (IDE) interface & sketch
Note: Any requirement to use a crystal ball or mind reading will result in me ignoring your question.
Criticising any questions is banned on this forum.
Any DMs sent on Twitter will be answered next month.
All non-medical doctors are on my foes list.
Criticising any questions is banned on this forum.
Any DMs sent on Twitter will be answered next month.
All non-medical doctors are on my foes list.
Re: Hard drive (IDE) interface & sketch
Or something like it. The power supply on mine failed because the two parts of the transformer in it were not glued together. Also there was no input filtering causing interference on the radio!. A replacement proper power supply and it works fine!