I`ve been setting up some systems which automatically configure everything on the SDCard, however I`ve now got to the point where "raspi-config" autostarting following an install isn`t needed.
Q1: Where does NOOBS kickstart raspi-config from? I can then stop it running if I need to.
Also, on a related note, the silentinstall option of NOOBS config... Is there a way to get it to silently install more than one OS (specifically I always want to install the "user data" partition but other OSs could be useful too).
Q2: Is it possible to run a silent install with Raspbian and a user data partition at the same time?
Would be great to finally be able to pop my sd-card in and everything is automatically setup each time.
(Obviously the whole will be documented and shared, all this is thanks to Kevin Hill`s NOOBS config)
(I`ve tried looking for the answers so sorry if they are mentioned somewhere I've not seen)