I have been searching google and tried 3-4 different approaches - but without any luck.
I would like my RPi3 to connect to my network - using WiFi if no cable is in eth0, and if a cable is connected to eth0, that should be the preferred interface.
Optimally the IP address is the same (static) - no matter whether I need to connect via WiFi or cabled network.
I am not sure whether bonding the network cards is the right solution - or using ifplugd ...
Has anyone had success in creating such a configuration? If yes, can you share your settings/config (disregard the SSID/PSK - of course I will need to use my own)
Thanks in advance