I have a brand new RPi 2 B with PCB labeled v1.1.
I use it with Samsung EVO 8 GB (MB-MP08D) µSD card.
I have this problem only with my Pi 2 : I tried to put this SD in one of my B+, I never seen this.
Most of the time, everything is fine, but some times (around one time over 6), on boot, I get the error described on this post :
http://www.raspberrypi.org/forums/viewt ... 28&t=22359
I can see this line followed by a lot of kernel debug lines about the module being loaded when the problem happens :
If I wait, I can see the same behavior reproduce in a loop with different kernel errors.mmc0: Controller never released inhibit bit(s)
When this happens, the only working solution I found is to reboot the Pi (using a keyboard or by taking power down).
I use the an up to date Raspbian image from the RPi official website.
I ran rpi-update yesterday.
My cmdline :
Am I the only one?dwc_otg.lpm_enable=0 console=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwait
Just got it 5 times in a row...
I noticed that every times, I get either :
or :mmcblk0: unknown error -5 sending read/write command, card status 0x900
or :mmcblk0: unknown error -110 transferring data, sector xxxxxx, nr 8, cmd response 0x900, card status 0x80000b00
In the last two, the sector number vary.mmcblk0: unknown error -110 transferring data, sector xxxxxx, nr 8, cmd response 0x900, card status 0xb00