I've connected the VCC to the 3.3V pin, the OUT to pin 15 (GPIO22) and GND to the ground pin.
I've install lirc, edited the /etc/modules file and that seems to be working properly, I have got an LED to flash with irsend and a remote config file I found online.
When I stop lirc and run mode2 -d /dev/lirc0 I get a continuous output of pulses and spaces like this:
Code: Select all
pulse 94779 space 438 pulse 299 space 586 pulse 27263 space 301 pulse 321931 space 220 pulse 8594 space 238 pulse 100533 space 453 pulse 119747 space 221 pulse 9710 space 252 pulse 59776 space 215 pulse 19717 space 213 pulse 49389 space 590 pulse 49708 space 269 pulse 29599 space 326 pulse 19410 space 665
Am I missing something here? Is my circuit wrong? Do I need to put a pull-up resistor or something in there? Sorry for all the questions I'm not too good with all the electronic side of things.
Thanks in advance