Page 1 of 1

Camera module not working

Posted: Thu Nov 02, 2017 2:34 pm
by DarkPlatinum
my raspberry pi camera module v1.3 is not working, try taking a photo, here is the error

[email protected]:~ $ raspistill -o image.jpg mmal: No data received from sensor. Check all connections, including the Sunny one on the camera board

so i used this command $ vcgencmd get_camera

output: supported=1 detected=1

so the red light comes on on the camera but doesnt take a picture. Tried rebooting to no success. Definetly not static discharge as the RPi still detects it. What can br the problem?

Re: Camera module not working

Posted: Thu Nov 02, 2017 3:45 pm
by DarkPlatinum
no one?

Re: Camera module not working

Posted: Thu Nov 02, 2017 3:49 pm
by DougieLawson
Is it the Omnivision sensor or the Sony sensor or some OEM camera?

Have you checked the Sunny connector is fully seated?

Re: Camera module not working

Posted: Thu Nov 02, 2017 4:51 pm
by DarkPlatinum
DougieLawson wrote:
Thu Nov 02, 2017 3:49 pm
Is it the Omnivision sensor or the Sony sensor or some OEM camera?

Have you checked the Sunny connector is fully seated?
1. sunny connector is connected, took it off and put it back on also.

2. Dont know which camera it is but its a rev. 1.3

Re: Camera module not working

Posted: Mon Nov 06, 2017 7:06 am
by DougieLawson
What's in /boot/config.txt?

My RPi with a "genuine" rev1.3 camera has

Code: Select all

gpu_mem=128
start_x=1
Try adding

Code: Select all

disable_camera_led=1