Hello! I got the CamJam Edu Kit as starting point to try out the GPIO features of the Pi but whatever I do, I can't get it working.
After deciding that I might be misreading the worksheets, I resorted to using this guide with the code here: https://thepihut.com/blogs/raspberry-pi ... -gpio-pins but again, I can't get anywhere.
If I go through the interfaces and enable SPI and leave the circuit in the above example wired up, the LED goes on and stays on once the Pi is powered and nothing I can do (except for disable SPI) turns it off.
I've just updated to Pixel and working through remote desktop access or directly on the Pi doesn't change anything.