Raspberry Pi Forums

OK so I have replaced my PiZero with a PiZero2 and Pi Camera. I tried to get the camera working but it was not recognised.
A suggested fix was to re-image the card so I downloaded the latest Jessie Lite flashed the image and went through the whole PITS installation again (I did not however remove the PITS board).

When I finally rebooted the Pi the tracker kicked in but a get a single band in dl-fldigi and a high pitched noise?

When looking at the tracker output in terminal the text is scrolling very fast compared to sending a telemetry string every second it is now sending about 20 a second!!

What I have I done?? Do I need to disconnect the Pi and reflash the image and install pits again!! Supposed to be doing a final comms test tomorrow

Have a read of the installation instructions, which were updated 2-3 weeks ago to take into account changes to serial port handling in Raspbian.

daveake wrote:Have a read of the installation instructions, which were updated 2-3 weeks ago to take into account changes to serial port handling in Raspbian.

Dave;

I did post a reply saying that I was following the pits manual however after looking at the Pi In The Sky Page Installing an SD Card From Scratch. (Which I had followed before). It would appear that you guys have updated it as you have mentioned. The pits manual has not yet been amended so that's what was throwing me

Thanks for pointing me in the right direction.

P.S. Why do I need Lora?

Do you need LoRa? I have no idea.

daveake wrote:Do you need LoRa? I have no idea.

Lora question (and my understanding) in another post.

PiZero / PITS / Camera - now all working fine - many thanks (Breaths a HUGE sigh of relief)