I have had the screen for some time now and it’s working perfectly. I just want to clarify something simple before breaking it
According to the instructions, the power and ground should be connected to pins 4 & 6.
Would it matter if the 5v was connected to pin 2 and the ground to one of the other ground pins, pin 9, 14, 20, 25, 30, 34,or 39?
I am thinking about connecting a 5v fan to the set up. The fan has a moulded 2pin connector so it would fit better on pins 4 & 6. I don’t want to cut the connector off the fan, and the wires from the screen are already separated.
Basically I just want to make sure there’s nothing special about pins 4 & 6 that i’m Not aware of.
You should always keep the prime objective in mind.
However, when you’re up to your ass in alligators, it’s hard to remember that you came to drain the swamp.