Page 1 of 1

Qlab OSC GPIO control

Posted: Fri Jan 04, 2019 1:18 pm
by EdwinvanSteenbergen
Does anybody know a possibility to use qlab to send OSC messages to Rpi to control GPIO output pins to control a servo motor. So far i can control the Rpi with qlab to reboot it or let it start and pause a video through Qlab from my Macbook pro. This thanks to :
Besides that I can also control a servo motor connected to my Rpi. Thanks to:
I hope there's someone who can help me out maybe to get these two things working as one, so controlling the servo through OSC messages sent from Qlab.

Edwin van Steenbergen