lvds…

fruitoftheloom

I've been searching the internet far and wide for a cable with which I could connect an lcd monitor pulled from an old laptop to my raspberry pi. I don't know exactly what the cable names are which made searching for this cable a lot harder than it needs to be. the lcd display has a flat 30pin conn...

aBUGSworstnightmare

Sharp LQ121S1LG81 timing #h_active_pixels = 800 #h_sync_polarity = 1 #h_front_porch = 168 #h_sync_pulse = 2 #h_back_porch = 86 #v_active_lines = 600 #v_sync_polarity = 1 #v_front_porch = 43 #v_sync_pulse = 2 #v_back_porch = 21 #v_sync_offset_a = 0 #v_sync_offset_b = 0 #pixel_rep = 0 #frame_rate = 60...

aBUGSworstnightmare

Just send an e-mail to <somebodys mail address > with details.
Let me know if you've received it.

dennisc

Hi,

made a mistake in writing it...

xxxx _at_ me _dot_ com

sorry!

aBUGSworstnightmare

yes, mapping is correct. I will let you know the details by e-mail.

have you received my e-mail btw?

aBUGSworstnightmare

yes, mapping is correct. I will let you know the details by e-mail.

have you received my e-mail btw?

dennisc

I think it is the right version!

: screen3.png (142.54 KiB) Viewed 5092 times

aBUGSworstnightmare

here is the datasheet! Pinout is not what I'm interrested in! I need to know the LVDS data mapping. So, please check your display spec for some informaton like the one shown below. R1R0mapping.jpg Your display need to have this mapping as there are no PCBs left which support Y0=..R3,R2 (look at the...

dennisc

here is the datasheet!

: screen2.png (105.22 KiB) Viewed 5110 times

dennisc

here we go!

xxx _at_ me _dot_ com

aBUGSworstnightmare

Please let me know how to get my email address across to you! Would like to buy one. do it in the same way as Thomas did in the post before yours! Let me know which display you want to connect (either post.the data sheet or a picture of the LVDS mapping) as I need to check if the remaining boards c...

klricks

Most screens with a HDMI interface and USB touch will work on a RPi. If you are thinking about interfacing a raw screen then some screens can use the DPI setup. See: https://www.raspberrypi.org/documentation/hardware/raspberrypi/dpi/ (Does not include touch interface). Generally though interfacing a...

chrhartz

Hi all, I made a pcb with the CM3L compute module and TFP401A HDMI to ttl decoder. I am using the DS90C385A ttl to LVDS driver from TI to drive a 10.1" 1280x800 IPS display from Duobond displays. It works generally. I am getting a stable picture with expected size, no flickering and colors are displ...

dennisc

Please let me know how to get my email address across to you! Would like to buy one.

aBUGSworstnightmare

I think I have one board with suitable LVDS mapping (Y0=..R1,R0) which I no longer need (due to my new approach based on CM3L). Problem is that I can't compete on price when compared to these low cost controllers on ebay as my board is assembled by hand and I only build a few (not millions of pieces...

qaz

Hello, I'd like to connect a LCD screen to a Raspberry Pi. I want to have as few and as small parts as possible, ideally it would only be Raspberry Pi with power supply and a screen, but after quite a lot of searching the only screen I could find that would work with Raspberry Pi without additional ...

fruitoftheloom

We have been asked to develop a WinIoT device for our customer based on the CM3 module. This device has to include a TFT display attached, preferably 7” LVDS (since we already use this in other products) (and yes, we aware of that CM3 is not official supported by MS) We consider ourselves having go...

clippererik

We have been asked to develop a WinIoT device for our customer based on the CM3 module. This device has to include a TFT display attached, preferably 7” LVDS (since we already use this in other products) (and yes, we aware of that CM3 is not official supported by MS) We consider ourselves having goo...

cgillinger

Just a follow up: I made it! And just to share if anyone else sets out to do a kiosk signage solution out of Pi Desktop: I followed the guides mentioned above, eg: 1. Installed: sudo apt-get install xdotool unclutter sed 2. Wrote (note that on ARM pi its "chromium-browser", here it should be just "c...

fruitoftheloom

Hi! TL;DR: Trying to get an older laptop with VGA-out to boot with Chromium in kioskmode on a tilted external display. I've just recently managed to set my actual Raspberry Pi to work as a signage solution with Chromium in kiosk mode. However some of the web-pages that are to be displayed apparentl...

cgillinger

Hi! TL;DR: Trying to get an older laptop with VGA-out to boot with Chromium in kioskmode on a tilted external display. I've just recently managed to set my actual Raspberry Pi to work as a signage solution with Chromium in kiosk mode. However some of the web-pages that are to be displayed apparently...

sheroy

This seems interesting.... I am right now talking about the CSI interface I would like to know if we can control the registers directly... ie data in and out... it looks like the CSI is based on the LVDS levels and thus could we hook up an LVDS based IO ADC to carry out the operation. I see 3 data p...

aBUGSworstnightmare

Nevermind, thank you! I'll figure out if i can reproduce the board from your schematics. Anyway thank you for the response and for the awesome work! which schematics are you referring to? These one -> https://drive.google.com/drive/folders/0B5lt0BFRhFlDb0xZODgtWjNsNXc sorry to say, but this wont he...

lpleo

I'm sorry, but all PCB's (LVDS add-on) are gone! What I still have is the small adapter for use with the original FPC. Nevermind, thank you! I'll figure out if i can reproduce the board from your schematics. Anyway thank you for the response and for the awesome work! which schematics are you referr...

aBUGSworstnightmare

I'm sorry, but all PCB's (LVDS add-on) are gone! What I still have is the small adapter for use with the original FPC. Nevermind, thank you! I'll figure out if i can reproduce the board from your schematics. Anyway thank you for the response and for the awesome work! which schematics are you referr...

Search found 1620 matches: lvds…

Re: Can't find a cable to connect an lcd display to my raspberry pi

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: Large TFT (Tablet) Touch Screen compatiblity list

Re: STICKY: HOWTO: Create Custom HDMI modes

Re: LVDS add-on for Raspberry models with 40pin GPIO

Re: Using laptop screen with RPI

Using laptop screen with RPI

Re: Question regarding CM3 compared to RPI3+ and DSI port.

Question regarding CM3 compared to RPI3+ and DSI port.

Re: Trying to make a Kiosk-mode out of Raspberry Pi Desktop for PC

Re: Trying to make a Kiosk-mode out of Raspberry Pi Desktop for PC

Trying to make a Kiosk-mode out of Raspberry Pi Desktop for PC

Re: DSI as GPIO

Re: Nexus 7 LCDs

Re: Nexus 7 LCDs

Re: Nexus 7 LCDs