hello!!

The link is off...do you know where I can get it? thanks

hello everyone! I'm using the snes emulator from retropie... basically it is that, sound is very glitched and crazy when playing zelda in the snes emulator…. I think it is the only rom in the snes emulator that is giving me this problem… Can I tweak the emulator in any way to enhance the sound? Than...

How can I put Dgen in Retropie to play european roms? All my roms run well but the one I want to play the most shows something like: "rom developed for use with PAL systems"...how can I turn around this?

Thank you!

eu também encomendei pela inmotion e veio tudo certinho e muito rápido!

hey! já tinha visto...mas não sei como hei de fazer isto:

To do this, store the following in /etc/apt/sources.list.d/mene.list:

deb http://archive.mene.za.net/raspbian wheezy contrib

q é o primeiro passo...podes-me dar uma ajuda?obrigado

já alguém conseguiu fazer isto? e se sim, pode explicar como?

já andei a correr alguns sites, mas não consigo passar sempre de algum passo de execução do processo...

obrigado

aLô!!

eu segui este guide que explica como instalar o RetroPie que é como um gerenciador de vários emuladores, no qual está também incluido emulador para o Super Nintendo... experimenta...

http://supernintendopi.wordpress.com/

Hello everyone! What is happening is that I'm using my Pi to install Retropie and play a little, and at the third or forth reboot the Pi doesn't boot... It only shows a red light and the television says no signal... Then I format the SD cart, put it an wheezy image and everything works fine till the...

so, after everything compiled sucessfully:

- DGEN freezes when launching games
- and gngeo, I can see in the terminal when launching the games something like /installdir/bin/gngeo: not found....

so...any ideas?=P

Thank you

about the rpix86 installation... Through the retropie setup continues to give me the error: could not compile successfully PC Engine Core... it inflates the .zip file and then doesn't do anything, simply exits.. through the terminal and looking to retropie_setup.sh the only think left to do is this?...

for the neogeo emulator (x86 haven't tried yet): I wrote (after make clean giving the same error): - the wget command - unpacked with tar - and ran config like in the file you showed... the configuration ran a little bit better but again fails on libeffect.a What I don't understand is if the Pi's ar...

in the folder gngeo-0.7 i've made:
-> ./configure
and when I do:
-> make
it starts welll but then gives error 1 and starts leaving directories and stops...
maybe something about "libeffect.a: could not read symbols: file in wrong format"?

don't know, just shooting in the dark...thanks

Hello!

I could successfully compile DGEN emulator but PC Engine core and NeoGeo emulator still says it couldn't compile them... I tried lowering the RAM value to 32 but gives the same result...trying to compile them through the terminal with commands will be the same?

Hello Aloshi! Thank you for your answer! I had tried to compiled them individually through /configure and /make like it says on installation notes in each emulator folder, but it didn't work...guess my compilations skills aren't the best...;) I will try that and say something later about how it is r...

hello everyone! I didn't know if I should post this here or in retropie page but tought that here there would be an ampler community to help... I did the installation of RetroPie by the book , but after the 6 hours it took to install, it said that could not compile Neo geo, could not compile PC engi...