Go to advanced search

by beta-tester
Mon Jan 06, 2020 8:46 am
Forum: Troubleshooting
Topic: Autossh in RC.local not working
Replies: 17
Views: 564

Re: Autossh in RC.local not working

What do you mean by enviroment doesnt match? i thing it means that, at the time of processing rc.local, /home/pi is not the current home path, pi is not the current user and that current user has no permission to access to the keys at /home/pi/.ssh/gc_rsa (as far as i know, only the user pi is the ...
by beta-tester
Mon Jan 06, 2020 7:05 am
Forum: Troubleshooting
Topic: SSH works, Internet doesn't, but only with Raspi, it's not the mac
Replies: 11
Views: 824

Re: SSH works, Internet doesn't, but only with Raspi, it's not the mac

it looks like that your RPi does not get a proper gateway. does it get a proper IPv4 address ? maybe only an IPv6, or nothing and your SSH connection is working because of avahi. what do you get: ip address | grep inet should be an ip address in range 192.168.2.xxx/24 if you got a proper IP v4 addre...
by beta-tester
Sun Jan 05, 2020 8:50 pm
Forum: Advanced users
Topic: what valid interface combinations for multi BSSID?
Replies: 2
Views: 221

Re: what valid interface combinations for multi BSSID?

thank you... so it must be at least #{ AP } <= 2 to have two different BSSID... is that right? valid interface combinations: * #{ managed } <= 1, #{ P2P-device } <= 1, #{ P2P-client, P2P-GO } <= 1, total <= 3, #channels <= 2 * #{ managed } <= 1, #{ AP } <= 1, #{ P2P-client } <= 1, #{ P2P-device } <=...
by beta-tester
Sun Jan 05, 2020 8:34 pm
Forum: General discussion
Topic: Is the revised RPI4 board with fixed USB-C available?
Replies: 31
Views: 4244

Re: Is the revised RPI4 board with fixed USB-C available?

Where would I even buy such a thing? In Finland. The price could get out of hand. brand was only an example. i am pretty sure a good sorted professional computer equipment store near by you will have such kind of stuff as well. ok, "near by you" can be diffucult in finland i guess. but you can onli...
by beta-tester
Sun Jan 05, 2020 8:23 pm
Forum: Advanced users
Topic: what valid interface combinations for multi BSSID?
Replies: 2
Views: 221

what valid interface combinations for multi BSSID?

hi, on hostapd.conf at the bottom, i read about multi BSSID support in hostapd, that not all wlan devices will supoort this mode. to figure out if the device is capable to do multi BSSID i should have to look what the folowing command shows: iw list | grep "valid interface combinations" -A 8 but the...
by beta-tester
Sun Jan 05, 2020 7:57 pm
Forum: General discussion
Topic: Is the revised RPI4 board with fixed USB-C available?
Replies: 31
Views: 4244

Re: Is the revised RPI4 board with fixed USB-C available?

I have long wondered why no one makes a power strip with a good space between each socket and sensible terminal orientation so that modern day stuff can be plugged into it neatly and space efficiently. there are such power strips available, but much more expensive see here , with those you can plug...
by beta-tester
Sun Jan 05, 2020 7:35 pm
Forum: Troubleshooting
Topic: [SOLVED] Raspberry Pi 4 not receiving 1000 Mbps
Replies: 16
Views: 1732

Re: Raspberry Pi 4 not receiving 1000 Mbps

I never expected that VNC would make such a big difference in speeds compared to SSH when testing. when you are remorely connected and run a speed test, that means that there is already network traffic going on. (remote connection traffic + speed test traffic = "real speed" speed test result = "rea...
by beta-tester
Sun Jan 05, 2020 11:30 am
Forum: General discussion
Topic: Is the revised RPI4 board with fixed USB-C available?
Replies: 31
Views: 4244

Re: Is the revised RPI4 board with fixed USB-C available?

i only read, that the VIA VL805 is a 4 port USB 3.0 controller... and somewhere i read that it has only 2 ports populated only because of not having enough room to trace all the wires to all ports. the speed limit of the bus is not an issue (even the RPi3B+ could not serve 1000Mb/s on its eth0 becau...
by beta-tester
Sun Jan 05, 2020 10:06 am
Forum: General discussion
Topic: Is the revised RPI4 board with fixed USB-C available?
Replies: 31
Views: 4244

Re: Is the revised RPI4 board with fixed USB-C available?

Why do you need it? just, because it's a shortage. It does not meet the USB-C specifications. could interfere with some OTG devices/functionality, not only power supplies... i think, when they make a respin of their PCB design, they will call that RPi then 4B+. (maybe whey will also find more room ...
by beta-tester
Sun Jan 05, 2020 9:34 am
Forum: Raspbian
Topic: Buster bug report thread
Replies: 313
Views: 72468

Re: Buster bug report thread

someSven wrote:
Sun Jan 05, 2020 4:56 am
I don't see what I could have done wrong...
what is the command route giving you? is your router listed there as gateway?
and with traceroute 8.8.8.8 you can see how far your ping is traveling.
by beta-tester
Sun Jan 05, 2020 6:31 am
Forum: Troubleshooting
Topic: [SOLVED] Raspberry Pi 4 not receiving 1000 Mbps
Replies: 16
Views: 1732

Re: Raspberry Pi 4 not receiving 1000 Mbps

Any suggestions would be welcome! I might reply slowly because I have to work but I will definitely try to reply as fast as possible. your iperf results fluctuates alot... (try to take a longer interval; iperf3 -i 10 ...) but you are not connected via VNC/SSH to your RPi while performing the speed ...
by beta-tester
Sat Jan 04, 2020 7:33 am
Forum: Troubleshooting
Topic: Raspberry Pi 3B+ Unable to sync to correct time
Replies: 34
Views: 3157

Re: Raspberry Pi 3B+ Unable to sync to correct time

first i would take a look what services are active: # should be active by default sudo systemctl status --no-pager systemd-timesyncd; sudo systemctl status --no-pager fake-hwclock; # should be not there or inactive by default sudo systemctl status --no-pager chrony* | grep Active; sudo systemctl sta...
by beta-tester
Sat Jan 04, 2020 7:02 am
Forum: Troubleshooting
Topic: Raspberry Pi 3B+ Unable to sync to correct time
Replies: 34
Views: 3157

Re: Raspberry Pi 3B+ Unable to sync to correct time

Hi guys, i have been having the same issue with the time not syncing on my pi 3b+ running retropie with stretch kernel. I can ping any of the ip addresses when you try to stop ntp and then do ntpd - q - g then restart ntp. All that does is scroll through a ton of ip addresses never ending till you ...
by beta-tester
Sat Jan 04, 2020 6:35 am
Forum: Troubleshooting
Topic: Raspberry Pi 3B+ Unable to sync to correct time
Replies: 34
Views: 3157

Re: Raspberry Pi 3B+ Unable to sync to correct time

If you want to run plain old ntpd you MUST run sudo systemctl disable systemd-timesyncd . this should be done automatically by the default start conditions of systems-timesyncd (depending what ntp service you are running/if it is listed in the start conditions) but, yes, disabling the service manua...
by beta-tester
Sat Jan 04, 2020 5:59 am
Forum: Raspbian
Topic: Buster bug report thread
Replies: 313
Views: 72468

Re: Buster bug report thread

it even doesn't work with ethernet, but again only internet doesn't work, I can SSH to get in... sounds to me more like a router configuration issue than a specific Buster issue. (i would recommend to ask that question in the forums troubleshooting category first, unless you know it is a Buster spe...
by beta-tester
Tue Dec 31, 2019 12:27 pm
Forum: Raspbian
Topic: Buster bug report thread
Replies: 313
Views: 72468

Re: Buster bug report thread

i hope this annoying %XX issue of the FileManager will get fixed soon.
but at the moment you only get useless/dumb answers.
by beta-tester
Fri Dec 27, 2019 2:56 pm
Forum: Troubleshooting
Topic: client_is_a_pi of dnsmasq is not working for a RPi4
Replies: 3
Views: 240

Re: client_is_a_pi of dnsmasq is not working for a RPi4

Do you mean to say the standard package has that in its default configuration files? What for? yes, when you install the package dnsmasq via "sudo apt install dnsmasq" to your raspbian buster, the default /etc/dnsmasq.conf file does include a logic at the end to set client_is_a_pi, when a network p...
by beta-tester
Fri Dec 27, 2019 2:29 pm
Forum: Advanced users
Topic: How to lock GPS (with pps) in Rpi!
Replies: 17
Views: 6665

Re: How to lock GPS (with pps) in Rpi!

1) if I manually set wrong date (sudo date...) I have wrong date until reboot.... why if my GPS has time locked wrong system time isn't updated to correct value? normally the wrong time will be adjusted very slowly to the correct time, because some applications will not work correctly, when the tim...
by beta-tester
Fri Dec 27, 2019 5:49 am
Forum: Troubleshooting
Topic: client_is_a_pi of dnsmasq is not working for a RPi4
Replies: 3
Views: 240

client_is_a_pi of dnsmasq is not working for a RPi4

when i install dnsmasq on an actual and updated/upgraded raspbian, it normally has a logic in its dnsmasq.conf to set a tag: client_is_a_pi , when the client is a raspberry pi. this is working for RPi0 to RPi3 only. for a RPi4 it isn't working. i took a look to my RPi4's mac and saw my RPi4 has a MA...
by beta-tester
Tue Dec 24, 2019 2:21 pm
Forum: Advanced users
Topic: How to lock GPS (with pps) in Rpi!
Replies: 17
Views: 6665

Re: How to lock GPS (with pps) in Rpi!

Mikeymp66 wrote:
Mon Dec 23, 2019 8:49 pm
... with the latest stretch made my Pi a stratum 1...
in the meantime raspbian buster is the actual version.
(the project RPi-GPS-PPS-StratumOne is working with raspbian buster as well)
by beta-tester
Mon Dec 16, 2019 12:01 pm
Forum: General discussion
Topic: RPi4 implementation progress/status
Replies: 7
Views: 809

Re: RPi4 implementation progress/status

is network boot now available? is hardware video acceleration h264 and h265 now fully implemented? is the second HDMI now fully working with hardware acceleration? is Wifi issues at some video modes still present? is it fixable in software? (except of not using those specific video modes) when i us...
by beta-tester
Sun Dec 15, 2019 9:38 pm
Forum: General discussion
Topic: RPi4 implementation progress/status
Replies: 7
Views: 809

RPi4 implementation progress/status

hello, is there somewhere a (sticky) thread available, where a full list of all implementation in progress (and recently finished) are listed that gets premanently updated with the current status? what features of the old RPi (or new features io the RPi4) are still fully missing for the RPi4, what f...
by beta-tester
Wed Dec 11, 2019 12:40 pm
Forum: Raspbian
Topic: Buster bug report thread
Replies: 313
Views: 72468

Re: Buster bug report thread

File Manager : when mounting SMB/CIFS shares via gvfs, either through the file manager "smb://server/share" or "gio mount smb://server/share" , the included pcmanfm file manager shows %20 instead of spaces in file names eg "My Music" shows as "My%20Music". It's not a bug, it's a feature. Simple fix...
by beta-tester
Wed Dec 11, 2019 10:34 am
Forum: Troubleshooting
Topic: [Fixed] File Manger shows spaces as %20 on network shares
Replies: 10
Views: 974

Re: File Manger shows %20 instead of spaces

LTolledo wrote:
Wed Dec 11, 2019 10:14 am
however if the network share is mounted via fstab (cant vouch for systemd method), those "cryptic codes" are not evident anymore
maybe... but i only want to connect the shares via the file manager when i need them.
by beta-tester
Wed Dec 11, 2019 9:53 am
Forum: Troubleshooting
Topic: [Fixed] File Manger shows spaces as %20 on network shares
Replies: 10
Views: 974

Re: File Manger shows %20 instead of spaces

i tried out PCmanFM on my PC by using debian-live-10.2.0-amd64-lxde.iso.
there the share looks normal:
Bildschirmfoto vom 2019-12-11 10-47-15.png
Bildschirmfoto vom 2019-12-11 10-47-15.png (52.01 KiB) Viewed 881 times

Go to advanced search