Its not the official version. But i had it working before with no issues. Then something got changed on the sd card and looked everything up so now im in the process of rebuilding. For the life of me i cant find what i did to fix it before.

Im sure its been covered before but im having issues with a 7" touch screen. I have it running correctly and displaying the image. I have over scan off and res set to 800x480. My issue is when i run the calibrator program when i touch the points it displays the pointer is off and even after completi...

i had forgotten about using a relay. Thats probably the easiest for me to do. All i want to know if its present so that would work.

Im looking to monitor 120 volts ac with a pi. Is there a sensor that can do that or do i need to go the route of using a transformer with a sensor?

The link you provided is the link that i had followed. I installed it and then node red crashed and i had to reinstall everything. I tried it again after a fresh install and the same thing happened.

i currently am using node red on a pi with flows monitoring 6 ds18b20's. I also have a thermocouple that i want to monitor and have a max31855 board as a amplifier. I have everything wired but after i add the node and try running it i lose connection with the node red sever. Is anyone experienced th...

So my goal is to monitor my boiler remotely. I have been using privateeyepi to monitor temps. I also have 2 other sensors i want to add. One is a 0-5 volt pressure sensor and another is a thermocouple that i have a break out board of max31885. I also have some Arduino boards laying around that i can...

I changed the pull up to a 2200k and for now it seems to be working.

i have checked the voltage and im reading 3.3 at the sensors of the long run. I even tried the 5 volt setup and no change. The thermostat wire is 20ga.

so im having issues seeing 6 soon to be 7 sensors. My issue is when i try to read them all i get is w1_bus_master1 respoonse. If i connect all the sensors to a bread board everything works fine and i can see all 6 but once i put them into the system i have then i can't see any. I have some a few fee...