I was installing the buster-lite.img file to an SD card following the guide from the official website. I have done this before and because it is a small file it generally takes no more than a couple minutes. The memory card slot in my laptop is a bit sensitive so when I moved the laptop it caused th...

So only one pi has lighttpd on it installed, The interface used is wlan0 for the meshnet apart from this node which is using it to connect to the internet at the min. the main aim is to be able to see the web server across the mesh network. Which i do not really have a clue what he means by this. th...

Recently made a MANET with 4 pi 3 model b's using the batman routing protocol for a project at university. The stage now is to run some tests using a webserver recommended by my supervisor. so far i have installed lighttpd on a pi by following a tutorial that also allows it to use PHP ( not sure if ...

Need to set up multiple pis as a MANET mesh network,. found out that the broadcom chip in the p 3 does not support mesh mode, i have tried installing batman-adv routing but there are very little successful tutorial or up to date information for stretch operating system. Does anyone know of any cheap...

Crating an Ad-hoc mesh network for around 5 raspberry pi3 model B's for part of my dissertation. So far i have managed to set up two in Ad-Hoc mode, been able to ping each other and TCP a simple message through listening ports from one pi to another using netcat. My problem is that on rebooting the ...

thanks for you reply, i cant remember how i done it but it worked out in the end, thanks for your help anyway

Trying to SSH (for headless setup) into my pi for the first time, its been set up, enabled SSH on the setting and also the username and password has been changed. using the command ssh "username@xxx.xxx.x.x" obviously replacing the username with mine and the ip address of the device in the provided ...