Yes, I have done it.

clicky wrote:Did you managed it now?

I couldn't find information about receiving the message at this site, but thanks for your helping.

ghp wrote:Hello,
eclipse paho library is very well documented: https://eclipse.org/paho/clients/java/
Hope this helps,
Gerhard

Thanks

mattlewis wrote:See https://github.com/mattjlewis/diozero/t ... visualiser

Matt

I could received the message and show it in python, but I need to subscribe message and show the message in my java GUI application. I am searching on the internet about this topic and I found the mqttcallback interface receiving MQTT message. Unfortunately, I haven't run code perfectly, yet. Does a...

kusti8 wrote: No. It would cost so much to repair it and you really have to be qualified and have the parts. Plus, they don't sell the chip individually and you can't really solder it to the board. Unless you're looking for something to do for the next year, no.

Thanks for your suggestion.

DougieLawson wrote:

btu wrote:Can i try to repair it? Is it possible?

The instructions to repair it are here: http://uk.farnell.com/raspberry-pi/rasp ... dp/2525225 it'll cost about $35

I will try.

Can i try to repair it? Is it possible?

I will probably buy a new one. Only i wanna learn the problem that was occurred. Thanks for your attention.

Inadvertently, i make short circuit it's 3.3v pin and 5v pin, but after that it continued working. Today, when i try to start the rp3, sometimes it works normally(also it becomes hot)

I have bought Rp3 and i have been using it for ten months. Recently, it's processor started to warm-up while i am using it. Yesterday, when i attempted to run it, it didn't boot on startup and it became too hot. When i touched to it approximately a few seconds, my finger became hot as touching boile...