DougieLawson wrote:You need to do that on your router/AP.

ahh ok. Well, if my roommates use wifi devices and they're not on the channel I set it on, do they lose wifi on their devices until they switch channels?

i'd hate to reconfigure everything in our place just to test the pi.

Look at the WiFi channel. Move away from channel 1 & channel 11 because they're extremely crowded with domestic APs running a default configuration. One of my APs runs on channel4, the other runs on channel 8. ahh I forgot to try this. I ran iwconfig wlan0 channel 6. However I get an error, set fai...

I was about to give up on my new raspberry pi 3. I could not connect the wifi. After much difficulty, I opened the configuration site in my Xfinity Technicolor TC8305C cable box and configured it on the Gateway Connection WiFi page; the Mac Filter Setting, Device Name to raspberrypi and the MAC Add...

PING 192.168.1.254 (192.168.1.254) 56(84) bytes of data. 64 bytes from 192.168.1.254: icmp_seq=1 ttl=64 time=3.15 ms 64 bytes from 192.168.1.254: icmp_seq=2 ttl=64 time=2.63 ms 64 bytes from 192.168.1.254: icmp_seq=3 ttl=64 time=2.66 ms 64 bytes from 192.168.1.254: icmp_seq=4 ttl=64 time=2.75 ms I u...

thanks for the hlep first of all, it is greatly appreciated. Also, sorry being a few days late on this but I've been busy and just go back to working on my pi. Bus 001 Device 007: ID 0a5c:bd1e Broadcom Corp. Bus 001 Device 006: ID 046d:c051 Logitech, Inc. G3 (MX518) Optical Mouse Bus 001 Device 005:...

so after the usb extension is plugged in, my iwconfig is displaying the exact same information with no extender. This should rule out RF interference, I suspect it is something else.

what settings can I look at to see if that will do the trick?

its the same dongle and I just put it in my other pi0. Each pi0 shows the exact same problem with no difference in speeds, it stays right around 65mb/s. My extender comes in tomorrow so i'll be able to test to see if its RF interference although I suspect that this isn't the case. Other users have s...

IEEE 802.11bgn ESSID:"ATT2hG4EzQ" Mode:Managed Frequency:2.412 GHz Access Point: F8:18:97:CE:DC:72 Bit Rate=65 Mb/s Tx-Power=31 dBm Retry short limit:7 RTS thr:off Fragment thr:off Power Management:on Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 ...

so I read the wifi thread which was closed by a mod saying that you should make a new post. I hope I'm reading that right becuase I know how annoying that can be to just ask for help. so over the weekend, I got a wifi adapter , http://raspi.tv/wp-content/uploads/2015/07/Official-Raspberry-Pi-WiFi-do...