I have come to understand that to "install" software on my Pi I need to use Etcher to move the image to my SD disk, however I am trying to get Etcher installed and after unzipping I ended up with a .AppImage file. I don't really know what the next steps are.

Can someone help?

Thanks,
Matt

Got everything working. Thanks for your help!

Guys - Thanks for all your wiring tips. After much troubleshooting, I found that there were some cold solder joints on the batter pack, which I fixed and the unit lit up when I turned on the power. Yay. Now, I did tap each of the 4 enables on the VCC and each motor went a different direction based o...

Here is the DC Motor Controller: http://www.mcmelectronics.com/product/OSEPP-MTD-01-/83-16560 http://www.mcmelectronics.com/content/productimages/s5/83-16560.jpg Here is the tank part: https://www.sinoning.com/damping-balance-tank-robot-chassis-crawler-for-arduino-diy-toy-sn1700.html.html three wire...

I've got the ASEPP MTD-1 DC motor Controller, and a tank track with 3 connectors (2 wires to each connector) - 1 battery, 1 to each motor. the batter is 9 volts. What I am really struggling with is the wiring and trying to figure out what wires go where. I can do the coding, but not the wiring. I ha...