I’m using a raspberry pi zero 1.3. I'm trying to set a GPIO pin high at boot and keep it high until shutdown. I added this line in config.txt which sets high gpio 5. dtoverlay=gpio-poweroff:gpiopin=“5”,active_low="y" When I hit in command prompt sudo shutdown -h now I get a kernel panic after shutdo...

The red led is on. The green led is constantly off with or without the hdmi cable and usb peripherals.

Would that be possible to damage a raspberry pi with a bad hdmi cable? I have 4 raspberies until now with the same problem. I got the under voltage warning on the screen permanently although I use the official power adapter and I measure 4.9-5.0 volts on the raspberry. The USB,ethernet and wifi are ...

As I mentioned above I have tried many power supplies including the original one. Also I tried 3 different cables including a custom made with 22AWG wires. I'm 100% sure that the problem is not the power supply. I'm pretty sure that the raspberry pi is fried since I measure 5.008-5.026V (using a pro...

I have tried many different sd cards. I have the under voltage warning with all of them. Somethng has fried my raspberry pi but Indon't know why and which component is fried. I get 5V on PP1, PP35 and PP7.

I have a raspberry pi 3 and I use it with a 5V/3A power supply. I plugged in another power supply I have inside an Arcade Machine and I got a constant under voltage warning. The USB ports were not working and I turned it off. I had used this power supply in the past and I was getting under voltage w...

I installed grblweb/reprapweb on a Raspberry 2. This command: uname -a returned this: Linux xyzbots 3.18.0-trunk-rpi2 #1 SMP PREEMPT Debian 3.18.5-1~exp1.co1 (2015-02-02) armv7l GNU/Linux so I tried to install drivers for 3.18.5-v7. I changed "3.18.5-v7" to "3.18.0-trunk-rpi2" in install.sh and inst...