I have a Raspberry Pi Compute Module that I was hoping to get running at Fastmode+ or 1MHz. I set up the I2C for both port0 and port1. I have an O-scope connected to both (reference is on GND pin). So there is no buffer or pull-up resistor here, just a straight connection to the scope. I set the bau...

Thank you for your reply. I have tried plugging the CM Pi into different USB ports (2.0 and 3.0) with no new results. I have also plugged the same system in the same way into a different computer running Windows XP and the PC recognizes it just fine. No device errors. Therefore, I do not think it is...

I have a Compute Module v1.1 and host PC running windows 7, and I am trying to flash the eMMC following the instructions provided online on raspberry pi foundation's website. 1. I downloaded and installed the Compute Module Boot tool 2. Plugged the CM slave USB to the host PC USB 3. Power the CM boa...