I did ensure the MAC addresses were correct. Due to another unrelated problem, I ended up having to reflash a clean copy of Raspbian and so also resolved the issue I was having with IP assignment. As soon as the refreshed pi connected to my network on its first boot, it was assigned the right IP.. s...

All, I think I'm very close to having a functional PICAN setup. From the multiple posts in this thread and the http://lnxpps.de/rpie/ page, everything seems to be looking good as far as configuration and bringing up the can0 interface. Now, I just need your HELP in understanding the solder joints (S...

/etc/network/interfaces: auto lo iface lo inet loopback iface eth0 inet dhcp allow-hotplug wlan0 iface wlan0 inet manual wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet dhcp /etc/wpa_supplicant/wpa_supplicant.conf: ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev update_co...

Hello all. Having a strange issue with my wireless connection. Upon first boot and rpi-config, the dongle I have connected just fine to my wifi network and (for whatever reason) chose the IP of 192.168.1.245. Connectivity is fine (eg web browsing). I want to give it a static IP of 192.168.1.177, tho...

2. Use the 3-pin terminal for CAN, and DB9 for OBDII only (check the schematic for jumper selection).

Why is this? Aren't the CAN High and CAN Low pins also present on the DB9 connector?
With an Arduino I have no troubles talking to CAN via DB9.

Kim (BigSjedow), did you find jtosey's post to be comprehensive enough to follow? I'm in the same boat as you but have mostly been biding my time waiting for a straightforward and effective how-to on getting the PICAN to work. I tried the instructions at http://skpang.co.uk/catalog/pican-canbus-boar...