Thanks Everyone my car has been made the modifications to the code have been made

So can some one sum up all the discussion
and tell me step by step with the gpio connections

BMS then what about the keyboard Commands

Anything wrong with the coding ???

I am using Jumpers and i am not using pwm Okay. If the jumpers are installed, your code and wiring can both forget that the enable pins even exist. If you only deal with the IN pins, you'll be fine. Also you can do PWM on the IN pins as well as the Enable ones. The only advantage is that you can se...

Sorry this is my first time in forums ,so i have corrected the code so now can you help with the code and wiring ,anyways can you tell me why was the terminal taking and accepting commands but the motors were not responding also could you give me an example code for enabling Thanks a ton !!!!!!!!!!

here,
gpio16-enb
gpio7-ena
gpio11-in1
gpio13-in2
gpio19-in3
gpio21-in4
gpio6-gnd
For above code

Tarcas can you explain this to me in detail(The wiring part )i am fairly new in hardware , This is my first pi Project ,This is the code i used : #These are the keyboard mappings #q = Go forward #a = Stop going forward or back #z = Go back #i= Go left #o = Stop steering #p = Go right #Get the GPIO m...

I am using Jumpers and i am not using pwm

Do i have to mention the enabled pins in the coding

And thnx Joan

Can you tell me which gpio pins should be connected to Enable A&B
If possible a diagram or a picture would be extremely useful
Thanks in advance

So i have been trying to make a remote controlled car using raspberry pi and a wireless keyboard i have referred to this video [Mod Removed link - video wrong] but it teaches to use only one motor all my materials are similar to those used in the video including the l298n h bridge Can anyone tell m...