Hi
Did you ever work out how to do this, i have the same problem

cheers

Hi I have been playing around with Qemu to simulate a pi on my mac, i have managed to get an image running but cant get qemu/pi to attach to the network, was wondering if anyone can point me in the right direction. sudo qemu-system-arm -kernel ./kernel-qemu-4.4.34-jessie -append "root=/dev/sda2 pani...

Well i fixed the error issue, turns out to be a dns issue with virgin , so just set googles dns servers up in the router and downloads fine. Still would like to know about an image for astro pi

cheers

Hi This is a noobs question so please be patient with me, I have 3d printed a astro pi and build the unit using a kit from cpc. however it did not come with a sd card so i have installed a new install of raspbian jessie. I have been following the instructions from the astro-pi-flight-case tutorial, ...

Hi I am following the following tutorial SETTING UP A RASPBERRY PI AS AN ACCESS POINT IN A STANDALONE NETWORK on the raspberry pi org site and when i get to setting up the interfaces file with a static ip i get an error on running sudo ifdown wlan0 i get the following error /etc/network/interfaces:2...

Thanks for the link, will check it out.
Cheers

Hi

Do you have the source code for the scroll and static demo's. I would like to play around with them as I am new to led matrices and not sure what I'm doing. YET

cheers

Hi Everyone I just purchased an 8 channel relay board from ebay to play with (http://www.ebay.com/itm/151105724470?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649). It looks ok saying its from china but came with no wiring instructions. On inspecting the board, I noted a jumper at the far end lin...

Thanks for the reply. I think I was over thinking the issue. Never thought to do it in software. I will be investigating this more.
cheers

Thanks for the reply. Im a software engineer, so writing the code was fairly easy, but when it comes to hardware Im a beginner. The problem requires each ride to start up, run at full speed for 3 mins or so and then slow down and stop, like a real ride. The motors are powered from a mains power supp...

Hi Guys I am looking for a similar solution. I have 8 RS 336-315 geared dc motors that I want to control. They need to run independent of each other or at a push two at a time. The motors power miniature fairground rides my brother-in-law makes. Motors are 12v 2.2w each. I have successfully powered ...

Hi
Has anyone succesfully installed this kernel module into raspbian. If you have can you please give a noob some pointers on how it was done. I have been following adafruits tuts but cannot find info on how to do it and do not want to use there image.

thnx

Hi
could you let me know how you installed the kernel module into weedy, im struggling with it. thnx

Hi
Im following this as im trying the same thing. Being new to the Pi and linux , can you tell me how you installed the kernel module in raspbian or did you use adafruits image.

thnx