Go to advanced search

by tpmcd
Sun Feb 14, 2016 6:02 pm
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

Re: SSH Troubleshooting [SOLVED]

I now have SSH access to the R-Pi working. I don't think "solved" is quite correct because I was unable to determine what caused the problem. A short while ago I downloaded a fresh Raspian image and re-flashed the card. I made no changes to the system and was able to connect via ssh. Thanks to all w...
by tpmcd
Sun Feb 14, 2016 4:15 pm
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

Re: SSH Troubleshooting

Here is a related question in the interest of troubleshooting. If I take the R-Pi and load a fresh image with zero changes and enable ssh with the config menu I believe I should be able to ssh to it using Port 22 is that correct? (To test I can shut down everything on the network except the two comp...
by tpmcd
Sun Feb 14, 2016 4:12 pm
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

Re: SSH Troubleshooting

Leaving Putty / RDP out of the discussion, it is clear that this works: you can ssh from the source 'sshd 1024' machine to a destination Linux machine. But what about the reverse direction? It should work assuming you are doing "ssh -p 1024 ...." from that destination machine to the machine that is...
by tpmcd
Sun Feb 14, 2016 4:05 pm
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

Re: SSH Troubleshooting

I'm a bit puzzled by 2. I edited /etc/ssh/sshd_config and changed the port to 1024 as I already had another machine using Port 22 on the network. You don't need to use different ports for each SSH server. If I have multiple machines on my local network that I ultimately want to connect to from the ...
by tpmcd
Sun Feb 14, 2016 4:24 am
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

Re: SSH Troubleshooting

Yes, I forgot to mention that I am able to ssh from the new R-Pi to itself using port 1024. I can also ssh from the R-Pi to another Linux machine on my network without a problem. When I issue the netstat command I get a similar response to what you show albeit with the expected port 1024 and a diffe...
by tpmcd
Sat Feb 13, 2016 11:17 pm
Forum: Advanced users
Topic: SSH Troubleshooting [SOLVED]
Replies: 10
Views: 1758

SSH Troubleshooting [SOLVED]

I have a Pi model 1 that I wanted to retask for a new project. I decided to load up a fresh image and begin with a clean state so earlier this week I installed the 2016-02-03 Raspian Jessie image. At this point I have made two changes: 1. I installed xrdp so I could connect using Remote Desktop from...
by tpmcd
Sun Nov 29, 2015 3:54 am
Forum: Advanced users
Topic: setting a static ipaddress in Jessie [Solved]
Replies: 5
Views: 3700

Re: setting a static ipaddress in Jessie [Solved]

I ran across this as well and found the DHCPCD information to configure my static IP address.

Question: Since the latest release now uses DHCPCD for configuring the interface why are the older configuration files, etc. left in place? It seems confusing. Do the old files still serve some purpose?

Tim

Go to advanced search