Go to advanced search

by PalfiZsolt
Thu Feb 22, 2018 10:38 pm
Forum: Beginners
Topic: OpenGL + Raspbian Stretch Lite
Replies: 2
Views: 861

OpenGL + Raspbian Stretch Lite

Hi, I would like to make a C/C++ hello triagle application with OpenGL on Raspberry Pi Zero W. However, I have set the Full KMS, Fake KMS OpenGL support and Legacy mode in the raspi-config and I have tried to run the /opt/vc/src/hello_pi/hello_triangle2 test in each cases. All of the cases I have re...
by PalfiZsolt
Tue Feb 20, 2018 5:33 pm
Forum: Networking and servers
Topic: How-to: AP+wifi client on Zero W with Stretch Lite
Replies: 16
Views: 15865

Re: How-to: AP+wifi client on Zero W with Stretch Lite

Hi, This solution works for me also on the latest official Raspbian lite package (Version:November 2017, Release date:2017-11-29). However, I always receive failed status for dhcpcd at boot process: Feb 20 17:27:58 raspberrypi dhcpcd[221]: Not running dhcpcd because /etc/network/interfaces Feb 20 17...
by PalfiZsolt
Fri Feb 16, 2018 8:07 am
Forum: Troubleshooting
Topic: Boot crash because of network configuration after update/upgrade
Replies: 5
Views: 893

Re: Boot crash because of network configuration after update/upgrade

Everything is good if I don't install the newest firmware-brcm80211. Is there any place where I can report this issue for the developers of brcm80211?
by PalfiZsolt
Fri Feb 16, 2018 7:35 am
Forum: Troubleshooting
Topic: Boot crash because of network configuration after update/upgrade
Replies: 5
Views: 893

Re: Boot crash because of network configuration after update/upgrade

I didn't have chance yet to try lblog's recommendation, but I tried to move the configuration to wpa_supplicant.conf. The result is the boot process finishes successfully, but after 5-10 seconds the boot process end, the same crash happens again. For me it seems the connecting to the network is just...
by PalfiZsolt
Thu Feb 15, 2018 12:41 pm
Forum: Troubleshooting
Topic: Boot crash because of network configuration after update/upgrade
Replies: 5
Views: 893

Boot crash because of network configuration after update/upgrade

Hi, I have the latest Raspbian Stretch Lite package (Release date:2017-11-29 Kernel version:4.9) on my Raspberry Pi Zero W. I didn't changed anything, the official state is on the device. I configured the net in the /etc/network/interfaces by adding these lines to the end of the file: auto wlan0 ifa...
by PalfiZsolt
Thu Feb 08, 2018 11:52 am
Forum: Troubleshooting
Topic: Pi Zero always reboots at startup
Replies: 2
Views: 745

Re: Pi Zero always reboots at startup

It seems I found the problem. It was the USB cable. I tried to use a combination of TypeA-TypeA cable and TypeA-MicroB transformer to provide power to Pi Zero. When I changed this to TypeA-MicroB cable, the problem was solved. The power adapter was good.
by PalfiZsolt
Tue Feb 06, 2018 12:43 am
Forum: Troubleshooting
Topic: Pi Zero always reboots at startup
Replies: 2
Views: 745

Pi Zero always reboots at startup

Hi, I have brand new Raspberry Pi Zero. I prepared an 32 GB SDcard with Raspbian Stretch Lite. I wrote the latest (Release date:2017-11-29, Kernel version:4.9) image file with Etcher to the SDCard without any error. My problem is that the Raspbian cannot start. I observe the rainbow screen, then I s...

Go to advanced search