Go to advanced search

by JacoFourie
Mon Feb 25, 2019 11:29 am
Forum: Troubleshooting
Topic: wlan0 gets de-associate after ap reboot
Replies: 9
Views: 367

Re: wlan0 gets de-associate after ap reboot

When you say my set-up should not work why do you say that? Can I not have 2 wifi connections on the same network on different IPs ? I have it that way on all my PI's. Why should it not work ?
by JacoFourie
Sun Feb 24, 2019 8:28 pm
Forum: Troubleshooting
Topic: wlan0 gets de-associate after ap reboot
Replies: 9
Views: 367

Re: wlan0 gets de-associate after ap reboot

I want to have a bond but when I started the project I was told I could not bond 2 wifi connections. The reason for 2 is just in case the one fails then I still have another. They both connect to the same AP but each on a separate IP. If I could have one IP on both WiFi connections that would be fir...
by JacoFourie
Sun Feb 24, 2019 4:55 pm
Forum: Troubleshooting
Topic: wlan0 gets de-associate after ap reboot
Replies: 9
Views: 367

Re: wlan0 gets de-associate after ap reboot

Are you using wpa_supplicant? Do you see wpa_supplicant processes running? There should be one process running by interface. Depending on your network setup: "ifconfig up/down" is equivalent to "ip link up/down". This is different from "ifup/ifdown" which go through /etc/network/* and launch variou...
by JacoFourie
Sun Feb 24, 2019 4:45 pm
Forum: Troubleshooting
Topic: wlan0 gets de-associate after ap reboot
Replies: 9
Views: 367

Re: wlan0 gets de-associate after ap reboot

I can update to stretch. I will take some time but I can do it. I have developed a controller to dry tobacco. https://www.youtube.com/watch?v=yAx9-Uk6Lck&t=6s There is no way to run a lan cable. It all works with WiFi. It is very stable but now and again the wifi will do this. And not matter what I ...
by JacoFourie
Sat Feb 23, 2019 12:44 pm
Forum: Troubleshooting
Topic: wlan0 gets de-associate after ap reboot
Replies: 9
Views: 367

wlan0 gets de-associate after ap reboot

Hi all. I have been running a number of Pi's in the field over the last 3 years. I have picked up some issues with the WiFi. Wifi will work 100%. All my PI's run on UPS power. Then if there is a power failure the AP will go down as that is not on back-up power. When the power comes back sometimes on...
by JacoFourie
Sat Dec 23, 2017 3:18 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

The Zero is so cheap. Who is going to fuss over warranty replacement? Well some people dont even want to pay 2 cents to fit the header at the factory it seems. What I take away from all this is dont solder on any Raspberry Pi boards. Then you are ok. In future I will ask the supplier before we do a...
by JacoFourie
Sat Dec 23, 2017 12:50 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Bottom line is those connectors are not populated, and the pins are not included, so adding them is a modification. I really don't understand why you find this so hard to understand. The composite video output connector is not populated. Nor are the GPIO connectors on most Pi Zero and Pi Zero W. Do...
by JacoFourie
Sat Dec 23, 2017 11:14 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

DougieLawson wrote:
Sat Dec 23, 2017 8:49 am
You should stop posting here (it's now a circular argument) and GO AND ASK YOUR HARDWARE VENDOR.
Thanks for your input. I got my answer. Regards.
by JacoFourie
Sat Dec 23, 2017 11:13 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

... most PCs have a on off and reset switch. Yes, and using that switch on just about any modern PC will result in OS corruption. Powering on/off your computer at-will has not been a reality for several decades. Modern computers and operating systems need a proper shutdown procedure (with few excep...
by JacoFourie
Sat Dec 23, 2017 8:44 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Your car analogy does not stand up for me. The Pi is a fully built, fully working thing when you buy it. Not a kit or self-assembly furniture. Then why is the run headers not populated. This car comes without a on off switch lol. Is that a feature lol. The car analogy is not mine btw. Because 99.99...
by JacoFourie
Sat Dec 23, 2017 5:23 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Heater wrote:
Sat Dec 23, 2017 5:08 am
Your car analogy does not stand up for me. The Pi is a fully built, fully working thing when you buy it. Not a kit or self-assembly furniture.
Then why is the run headers not populated. This car comes without a on off switch lol. Is that a feature lol.
The car analogy is not mine btw.
by JacoFourie
Sat Dec 23, 2017 4:43 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Thanks all for the input. I just wanted to know If I void the wranty by adding the pins as there are a lot of info on the net about adding them but nobody says you loose your waranty by doing it. Suppliers do, we do. And, tbh, it should be fairly obvious. Fiddle with the engine on your new car, you...
by JacoFourie
Fri Dec 22, 2017 8:45 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Thanks all for the input. I just wanted to know If I void the wranty by adding the pins as there are a lot of info on the net about adding them but nobody says you loose your waranty by doing it.
by JacoFourie
Fri Dec 22, 2017 5:00 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Heater wrote:
Fri Dec 22, 2017 4:58 pm
This is silly. One can't expect a vendor to warranty a device after you have attacked it with a soldering iron.

"Warranty void if modified" should be obvious enough to anyone.
Thanks for your input. It is noted.
by JacoFourie
Fri Dec 22, 2017 4:52 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

@JacoFourie You can start a Pi by pulling GPIO3 on the normal header low (short pin #5 to #6), there is no need to use the 'Run' pins for this. Hi. You need to enable I2C to use the UPS HAT http://www.raspberrypiwiki.com/index.php/Raspi_UPS_HAT_Board When you do that that method to start the Pi no ...
by JacoFourie
Fri Dec 22, 2017 4:40 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

interesting to know how to Wake from Halt - eLinux.org it's OT though Hi Sparkie. I found that if you enable I2C then those pins no longer work that way. I need I2C to read the SOC of the UPS. http://www.raspberrypiwiki.com/index.php/Raspi_UPS_HAT_Board Or is there another way to have I2C and the w...
by JacoFourie
Fri Dec 22, 2017 4:36 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

He may have altered it by soldering the pins (which is part of the Pi design). But that does not mean it arised because he did that, somewhere some proof would be needed to show it did/did not arise from that. WiFi not working should have nothing to do with it. Starting may have because it is linke...
by JacoFourie
Fri Dec 22, 2017 4:34 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

1) I've used these pins without issue. In the niche of people doing external watch dog stuff, it's probably the norm to use these pins. 2) You probably want to check your soldering station to verify that it is ESD safe, your are using good soldering technique, and that whatever circuitry you are at...
by JacoFourie
Fri Dec 22, 2017 4:32 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

I will pay 2 cents extra for the headers. No problem lol. But will all of the other 17M buyers? Total cost to the Foundation of adding those connects at 2c each (I've used your price), $340k. And no, we woudlnt; put the price up to $35.02 to compensate. Total number of people who need that connecto...
by JacoFourie
Fri Dec 22, 2017 4:28 pm
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

@JacoFourie You can start a Pi by pulling GPIO3 on the normal header low (short pin #5 to #6), there is no need to use the 'Run' pins for this. Hi. You need to enable I2C to use the UPS HAT http://www.raspberrypiwiki.com/index.php/Raspi_UPS_HAT_Board When you do that that method to start the Pi no ...
by JacoFourie
Fri Dec 22, 2017 11:57 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

I will pay 2 cents extra for the headers. No problem lol.
by JacoFourie
Fri Dec 22, 2017 11:49 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

If I have to use those pins again I will try these

https://www.sparkfun.com/products/retired/10527

Why dont they just solder them from the start is beyond me.
by JacoFourie
Fri Dec 22, 2017 11:22 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

OK I will take this one as a lesson learned. But then all should be warned that if you add pins to the run / reset pins you void your warranty. On the other hand lets say I did check the boards and all was fine. I solder the pins and all is still fine. and in 2 months time its stops working. Then th...
by JacoFourie
Fri Dec 22, 2017 10:38 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Re: Warrenty of the Pi ?

Because that connection is not required for normal operation. I've been using Pi computers for years and never found I needed it. Modification of almost any product will void the warranty. That's pretty standard warranty stuff. It's actually quite rare to find the opposite, so you should have thoro...
by JacoFourie
Fri Dec 22, 2017 7:38 am
Forum: General discussion
Topic: Warrenty of the Pi ?
Replies: 63
Views: 5360

Warrenty of the Pi ?

Hi. Can somebody from the Pi Foundation please clear something up for me. The Pi run / reset pins do not come populated with pins. I was told I had to solder them on my self. I bought 7 Pi boards for a project I am working on and soldered the pins on as required. I found one of the boards did not bo...

Go to advanced search