Go to advanced search

by ti_chris
Fri Aug 10, 2018 5:22 am
Forum: Interfacing (DSI, CSI, I2C, etc.)
Topic: Serial loopback not working with new build
Replies: 0
Views: 262

Serial loopback not working with new build

I'm trying to setup my alarmdecoder with the latest build (It all used to work with Jessie) and I'm running into some issues just getting the serial port to work now (let alone the alarmdecoder) :(. Thus I've done a simple test. I've disconnected the alarmdecoder from Rx/Tx and I've shorted Rx and T...
by ti_chris
Sun Feb 07, 2016 9:59 pm
Forum: Interfacing (DSI, CSI, I2C, etc.)
Topic: Triac selection
Replies: 7
Views: 1033

Re: Triac selection

No, the peak gate current is the maximum current that can flow through the Gate without damaging the Triac. So you just put a current-limiting resistor in series with the gate drive (just like driving an LED). pick some reasonable Gate current like 10mA. Makes sense. With a voltage drop of 1.3V and...
by ti_chris
Sun Feb 07, 2016 12:50 pm
Forum: Interfacing (DSI, CSI, I2C, etc.)
Topic: Triac selection
Replies: 7
Views: 1033

Triac selection

Hi, I'm looking at using a triac to trigger & control a 24VAC/1.5A control signal. I could use 2 triacs to get it done, but I'd much rather use a single one if I can. I have found: http://www.littelfuse.com/~/media/electronics/datasheets/switching_thyristors/littelfuse_thyristor_lxx04xx_qxx04xx_data...

Go to advanced search