Go to advanced search

by Maarten M
Wed Apr 08, 2015 12:00 pm
Forum: HATs and other add-ons
Topic: Gertbot as DCC Programmer?
Replies: 14
Views: 4455

Re: Gertbot as DCC Programmer?

I am ..The DCC decoder has not acknowledged any of my programming attempts. The Gertbot I/O section has no way to read responses. How do you know you are not getting any? I try to change the Address (CV1) and afterwards verify the decoder still repsonds to command addressed to the original or new a...
by Maarten M
Wed Apr 08, 2015 11:30 am
Forum: HATs and other add-ons
Topic: Gertbot - Bug when switching from DCC to DC-Brush mode
Replies: 3
Views: 1112

Re: Gertbot - Bug when switching from DCC to DC-Brush mode

I will wait for the update.

Many thanks
by Maarten M
Mon Apr 06, 2015 9:39 pm
Forum: HATs and other add-ons
Topic: Gertbot as DCC Programmer?
Replies: 14
Views: 4455

Gertbot as DCC Programmer?

I am trying to use the DCC mode and a sequence of commands to create a DCC programmer. I have not had any success so far. I can use the Gertbot as DCC controller without any problems. Using the DCC standard for service mode I tried to change a DCC address using a sequence of DCC reset messages follo...
by Maarten M
Mon Apr 06, 2015 9:21 pm
Forum: HATs and other add-ons
Topic: Gertbot - Bug when switching from DCC to DC-Brush mode
Replies: 3
Views: 1112

Gertbot - Bug when switching from DCC to DC-Brush mode

Using the version 2.3 software on a Gertbot with a RPi B+, after I switch from DCC mode to DC-brushed, the duty cycle always remains at 50% and cannot be changed using the PWM duty cycle command. After power-cycling the board, the PWM command acts as intended again. I assume the duty cycle remains u...

Go to advanced search