Go to advanced search

by w9lp
Wed Aug 19, 2015 5:53 pm
Forum: HATs and other add-ons
Topic: Gertbot Control using Python Drivers
Replies: 8
Views: 6266

Re: Gertbot Control using Python Drivers

Wanted to post a conclusion: Gert nailed it... explicitly invoking Python3 and refactoring my code resolved the issue. Continuing my journey with Gertbot. Thanks Gert!
by w9lp
Tue Aug 18, 2015 2:57 pm
Forum: HATs and other add-ons
Topic: Gertbot Control using Python Drivers
Replies: 8
Views: 6266

Re: Gertbot Control using Python Drivers

Thank-you for your prompt reply Gert. Helps to know there are others already using these drivers without issues.

I went back and confirmed that my RPi was NOT invoking Python3 during execution... obviously a problem. I'll rework my own code and try again. Many Thanks!
by w9lp
Tue Aug 18, 2015 3:03 am
Forum: HATs and other add-ons
Topic: Gertbot Control using Python Drivers
Replies: 8
Views: 6266

Gertbot Control using Python Drivers

I've been back through forum posts spanning several years... haven't found anything on point. Apologies if this is duplicative. I'm using RPi Model 2 and Gertbot board purchased recently to drive two small stepper motors. So far, hardware is set up and operational... I can launch Debug GUI and contr...

Go to advanced search