Go to advanced search

by hayt
Thu Oct 01, 2015 7:49 pm
Forum: Automation, sensing and robotics
Topic: L298N H Bridge Motor Board question?
Replies: 3
Views: 662

Re: L298N H Bridge Motor Board question?

By the six pins do you mean ENA, ENB, IN1, IN2, IN3, and IN4? If you use the same GPIOs to control both motor driver boards then both boards will be doing the same thing. Is that what you want? Yes, thats exactly what i had in mind. I want to divide the load between 2 H bridge controlers, but i don...
by hayt
Thu Oct 01, 2015 7:20 pm
Forum: Automation, sensing and robotics
Topic: L298N H Bridge Motor Board question?
Replies: 3
Views: 662

L298N H Bridge Motor Board question?

Hello everyone. I am planning to build small robot car. I was reading a lot online, but i still cant find all info or i cant figure out all stuff regarding the car. I dont want to test some stuff on my setup cause i might burn out something so i decided to ask first. At the moment I have 2 JGA25-370...
by hayt
Thu Sep 24, 2015 1:21 pm
Forum: General discussion
Topic: Why are some GPIO giving 3.3V at startup?
Replies: 8
Views: 1351

Why are some GPIO giving 3.3V at startup?

I have RPI B+ with Raspbian installed. I was trying to connect L298N for 2 days and i was not able to make it work correctly. For example. One motor was turning forward and other back, in different case one motor was turning and other not. When i changed pins they started running correctly. I was us...

Go to advanced search