Go to advanced search

by DrCarrots
Mon Sep 22, 2014 8:14 am
Forum: HATs and other add-ons
Topic: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?
Replies: 31
Views: 10686

Re: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?

Yes, I'm using the same image. I made the changes to /etc/rpusbdisp/rpusbdispd.sh and successfully booted to the console with my HDMI display connected. But when I boot with the Robopeak display, I get a blank screen at the end of the boot process (looking at the centre of the too large display outp...
by DrCarrots
Sun Sep 21, 2014 11:48 am
Forum: HATs and other add-ons
Topic: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?
Replies: 31
Views: 10686

Re: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?

Hmpf. 4 hours to be moderated (up 8 posts). My fault for living on the far side of the planet...

Thanks Dougie, I'll give your instructions a try tomorrow. My RPi is busy doing a night time lapse right now.
by DrCarrots
Sun Sep 21, 2014 6:15 am
Forum: HATs and other add-ons
Topic: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?
Replies: 31
Views: 10686

Re: Console Boot with 2.8" LCD TFT USB Robopeak? Possible ?

I'm having the exact same problem as TwinyTwice. I've had my RPi all of two weeks - very new to this - and took the "easy" route of using Robopeak's prebuilt firmware of Raspbian dated 9 September 2014. The additional info I can add to the above is that when you run sudo raspi-config and attempt to ...

Go to advanced search