Industrial use of the Raspberry Pi
The Raspberry Pi is often used as part of another product. This documentation describes some extra facilities available to use other capabilities of the Pi.
Customer OTP settings
There are a number of OTP values that can be used. To see a list of all the OTP values, you can use:
[email protected]:~ $ vcgencmd otp_dump
Some interesting lines from this dump are:
- 28 - Serial number
- 29 - Ones complement of serial number
- 30 - Revision number
Also, from 36 to 43 (inclusive), there are eight rows of 32 bits available for the customer
To program these bits, you will need to use the vcmailbox. This is a Linux driver interface to the firmware which will handle the programming of the rows. To do this, please refer to the documentation here, and the vcmailbox example application here.
The vcmailbox application can be used directly from the command line on a Raspberry Pi Raspbian build. An example usage would be:
[email protected]:~ $ /opt/vc/bin/vcmailbox 0x00010004 8 8 0 0 0x00000020 0x80000000 0x00010004 0x00000008 0x800000008 0xnnnnnnnn 0x00000000 0x00000000
The above uses the mailbox property interface
GET_BOARD_SERIAL with a request size of 8 bytes and response size of 8 bytes (sending two integers for the request 0, 0). The response to this will be two integers (0x00000020 and 0x80000000) followed by the tag code, the request length, the response length (with the 31st bit set to indicate that it is a response) then the 64 bit serial number (where the MS 32bits are always 0).
To set the customer OTP values you will need to use the
SET_CUSTOMER_OTP (0x38021) tag as follows:
[email protected]:~ $ /opt/vc/bin/vcmailbox 0x00038021 [8 + number * 4] [8 + number * 4] [start_num] [number] [value] [value] [value] ...
start_num= the first row to program from 0-7
number= number of rows to program
value= each value to program
So, to program OTP customer rows 4, 5, and 6 to 0x11111111, 0x22222222, 0x33333333 respectively, you would use:
[email protected]:~ $ /opt/vc/bin/vcmailbox 0x00038021 20 20 4 3 0x11111111 0x22222222 0x33333333
This will then program rows 40, 41, and 42.
To read the values back, you can use:
[email protected]:~ $ /opt/vc/bin/vcmailbox 0x00030021 20 20 4 3 0 0 0 0x0000002c 0x80000000 0x00030021 0x00000014 0x80000014 0x00000000 0x00000003 0x11111111 0x22222222 0x33333333
If you'd like to integrate this functionality into your own code, you should be able to achieve this by using the vcmailbox.c code as an example.
Locking the OTP changes
It is possible to lock the OTP changes to avoid them being edited again. This can be done using a special argument with the OTP write mailbox:
[email protected]:~ $ /opt/vc/bin/vcmailbox 0x00038021 8 8 0xffffffff 0xaffe0000
Once locked, none of the customer OTP values can be accessed.